PULLEY-IDLER
REMOVAL
1. Raise vehicle on hoist.
2. Remove belt splash shield.
3. Remove accessory drive belt (Refer to 7 - COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL).
4. Remove idler pulley mounting bolt. Remove idler pulley (5 or 9).
INSTALLATION
1. Position pulley (5 or 9) in mounting position. Install idler pulley mounting bolt. Tighten bolt to 48 N·m (35 ft. lbs.).
2. Install accessory drive belt (Refer to 7 - COOLING/ACCESSORY DRIVE/DRIVE BELTS - INSTALLATION).
3. Install belt splash shield.
4. Lower vehicle.