U1415-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION RECEIVED
For a complete wiring diagram Refer to Section 8W
- When Monitored:
Continuously with the ignition on.
- Set Condition:
When the All Wheel Drive (AWD) Module detects an incorrect CAN messages from the Engine Control Module (ECM) or the Totally Integrated Power Module (TIPM).
| Possible Causes |
| TOTALLY INTEGRATED POWER MODULE (TIPM) NOT CONFIGURED CORRECTLY |
| TIPM CAN BUS DTCS |
| ENGINE DTCS |
| ALL WHEEL DRIVE (AWD) CONTROL MODULE |
Diagnostic Test
1. CHECK IF TIPM CAN BUS DTC'S ARE PRESENTWith the scan tool, read TIPM DTCs.
Are there any TIPM CAN BUS DTC's present?
Yes
- Refer to 8-ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING and diagnose the appropriate symptom.
- Perform AWD VERIFICATION TEST - VER 1. (Refer to 3 - DIFFERENTIAL & DRIVELINE/ELECTRONICALLY CONTROLLED CLUTCH - STANDARD PROCEDURE)
No
- Go To 2
2. CHECK IF ENGINE DTC'S ARE PRESENT
With the scan tool, read Engine DTCs.
Are there any Engine DTC's present?
Yes
- Refer to the 9 - ENGINE ELECTRICAL DIAGNOSTICS and diagnose the appropriate symptom.
- Perform AWD VERIFICATION TEST - VER.
No
- Using the schematics as a guide, check the AWD Module pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the AWD Module per the Service Information.
- Perform AWD VERIFICATION TEST - VER. (Refer to 3 - DIFFERENTIAL & DRIVELINE/ELECTRONICALLY CONTROLLED CLUTCH - STANDARD PROCEDURE)