STANDARD PROCEDURE
AWD - PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE
For a complete wiring diagram Refer to Section 8W.
Perform the following pre-diagnostic troubleshooting procedures prior to performing any diagnostic test.
Always perform diagnostics with a fully charged battery to avoid false symptoms.
1. With the scan tool, read ABS DTCs. If ABS DTCs are present, (Refer to 5 - BRAKES - DIAGNOSIS AND TESTING) and perform to the appropriate diagnostic procedure(s) before proceeding.
2. Check the vehicles repair history.
3. If the vehicle has a repair history that pertains to the customer's current complaint, review the repair.
4. Check for any TSBs related to the customer's complaint.
5. Inspect the vehicle for any aftermarket accessories that may have been installed incorrectly.
6. With the scan tool, read All Wheel Drive (AWD) Control Module DTCs. Record all Stored, Active, and Pending DTC information. Diagnose any Pending DTC as a matured DTC.
7. Use the wiring diagram as a guide, inspect the wiring and connectors related to this circuit and repair as necessary.
8. Refer to the When Monitored and Set Conditions for this DTC. DTCs can set at ignition on, at start up, driving under specific conditions, and after controller diagnostic monitors have run or otherwise known as a Good Trip.
9. Check for any Service Information Tune-ups or Service Bulletins for any possible causes that may apply. Check for controller software update information. Some conditions can be corrected by upgrading the Engine (PCM) controller software.
Did any of the above procedures repair the vehicle?
Yes
- Testing is complete.
- Perform AWD Control Module VERIFICATION TEST. (Refer to 3 - DIFFERENTIAL & DRIVELINE/ELECTRONICALLY CONTROLLED CLUTCH - STANDARD PROCEDURE)
No
- Refer to the identified category and perform the appropriate symptom(s). (Refer to 3 - DIFFERENTIAL & DRIVELINE/ELECTRONICALLY CONTROLLED CLUTCH - DIAGNOSIS AND TESTING)
AWD CONTROL MODULE VERIFICATION TEST
Diagnostic Test
1. AWD CONTROL MODULE VERIFICATION TESTDisconnect all jumper wires and reconnect all previously disconnected components and connectors.
With the scan tool, select Clear Stored DTCs.
Make sure that all accessories are turned off and that the battery is fully charged.
Test drive the vehicle and verify proper operation.
With the scan tool, select View DTCs in the AWD Control Module.
Are there any DTCs present in the AWD Control Module?
Yes
- Return to the symptom list and perform the appropriate diagnostic test.
No
- Repair is complete.