REMOVAL
LAMP
1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Remove the front wheel and tire on the same side of the vehicle as the fog lamp being serviced. (Refer to 22 - TIRES/WHEELS - REMOVAL).
4. Remove the three screws (1) that secure the outboard side of the front wheel house splash shield (4) to the front fascia (2).
5. Remove the push pin fastener (3) that secures the inboard side of the splash shield to the front end sheet metal.
6. Remove the two push pin fasteners that secure the forward edge of the splash shield to the front fascia closure panel.
7. Fold the front of the splash shield rearward far enough to access the back of the front fascia.
8. Disconnect the engine compartment wire harness (1) connector (2) from the front fog lamp bulb (3) connector receptacle.
9. Remove the two screws (4) that secure the lamp to the back of the front fascia (5).
10. Remove the lamp from the seat in the face of the fascia.
BULB
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Remove the front wheel and tire on the same side of the vehicle as the fog lamp being serviced. (Refer to 22 - TIRES/WHEELS - REMOVAL).
4. Remove the three screws (1) that secure the outboard side of the front wheel house splash shield (4) to the front fascia (2).
5. Remove the push pin fastener (3) that secures the inboard side of the splash shield to the front end sheet metal.
6. Remove the two push pin fasteners that secure the forward edge of the splash shield to the front fascia closure panel.
7. Fold the front of the splash shield rearward far enough to access the back of the front fascia.
8. From behind the front fascia (2) disconnect the engine compartment wire harness connector (1) from the front fog lamp bulb (4) connector receptacle.
9. Firmly grasp the bulb on the back of the front fog lamp housing (3) and rotate it counterclockwise about 30 degrees to unlock it.
10. Pull the bulb straight out from the keyed opening in the housing.