DIAGNOSIS AND TESTING
POWER FOLDAWAY MIRROR SWITCH - RHD
The following test is designed to be used only on vehicles equipped with power foldaway side view mirrors.
1. Remove power mirror switch from mounting position (Refer to 8 - ELECTRICAL/POWER MIRRORS/POWER FOLDAWAY MIRROR SWITCH - REMOVAL).
2. Using an ohmmeter, test for continuity between the terminals of the switch as shown in the tables below.
NOTE: When testing using the chart below be certain to read the chart correctly. Example - When testing left mirror “DOWN↓”, pins 1, 9, 10 will show continuity to each other but not with 3, 4, 5.
3. If test results are not obtained as shown in the tables below, replace the switch.
EXTENDED MIRROR SWITCH CIRCUIT TEST
NOTE: Mirror position switch must be in the “extended” position to use chart below.
| WOBBLE PLATE POSITION | LEFT MIRROR SELECTED | RIGHT MIRROR SELECTED |
| CONTINUITY BETWEEN PINS | CONTINUITY BETWEEN PINS | |
| DOWN | 1, 9, 10 | 6, 9, 10 |
| 3, 4, 5 | 3, 4, 5 | |
| UP | 1, 4, 5 | 6, 4, 5 |
| 3, 9, 10 | 3, 9, 10 | |
| RIGHT | 2, 9, 10 | 7, 9, 10 |
| 3, 4, 5 | 3, 4, 5 | |
| LEFT | 2, 4, 5 | 7, 4, 5 |
| 3, 9, 10 | 3, 9, 10 |
RETRACTED MIRROR SWITCH CIRCUIT TEST
NOTE: Mirror position switch must be in the “retracted” position to use chart below.
| WOBBLE PLATE POSITION | LEFT MIRROR SELECTED | RIGHT MIRROR SELECTED |
| CONTINUITY BETWEEN PINS | CONTINUITY BETWEEN PINS | |
| DOWN | 1, 3, 4, 9 | 3, 4, 6, 9 |
| UP | 1, 3, 4, 9 | 3, 4, 6, 9 |
| RIGHT | 2, 3, 4, 9 | 3, 4, 7, 9 |
| LEFT | 2, 3, 4, 9 | 3, 4, 7, 9 |