POWER FOLDAWAY MIRROR SWITCH - RHD
REMOVAL
1. Disconnect and isolate the battery negative cable .
2. Remove the front door bolster. (Refer to 23 - BODY/DOOR - FRONT/DOOR - REMOVAL).
3. Disconnect the electrical harness connectors.
4. With the bolster on the bench, gently pry in on the tabs of the mirror switch and push through the front of the cover and remove.
INSTALLATION
1. Place the mirror switch in bolster opening and firmly snap into place.
2. Connect the electrical harness connectors.
3. Install the front door bolster. (Refer to 23 - BODY/DOOR - FRONT/DOOR - INSTALLATION)
4. Connect the battery negative cable.