INSTALLATION
LAMP
1. Align the liftgate lamp (2) to the mounting hole in the face of the liftgate trim panel (1).
2. Using hand pressure, press the lamp firmly and evenly into the mounting hole until the lamp latch features snap into place.
3. Reconnect the wire harness connector (3) to the back of the lamp housing.
4. Reinstall the trim onto the liftgate inner panel. (Refer to 23 - BODY/DECKLID/HATCH/LIFTGATE/TAILGATE/TRIM PANEL - INSTALLATION).
5. Reconnect the battery negative cable.
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.
1. Align the base of the bulb (4) with the bulb holder within the liftgate lamp housing (3).
2. Push the bulb into the holder until the base is fully seated.
3. Align the lens (5) to the lamp housing.
4. Using hand pressure, press firmly and evenly on the lens until it snaps into place over the lamp housing.
5. Reinstall the lamp into the liftgate trim panel (1). (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - INTERIOR/LIFTGATE LAMP - INSTALLATION).
6. Reconnect the battery negative cable.