INSTALLATION
BULB - FRONT
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.
NOTE: Two different front dome lamps are available, one for vehicles without a sunroof and a second for vehicles with a sunroof. The only differences between these lamps are that the one for sunroof applications has a mount for a power sunroof switch within the lamp housing, an opening in the center of the lamp lens through which the sunroof switch rocker protrudes, and an opening on the back of the lamp housing through which the sunroof switch connector receptacle protrudes. The lamp and bulb service procedures are the same for either lamp.
1. With the dome lamp lens (1) in the open position, align the ends of the bulb (3) with the two bulb holders within the front dome lamp housing (2).
2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place.
3. Reinstall the lamp into the headliner. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - INTERIOR/DOME LAMP - INSTALLATION/FRONT DOME LAMP).
4. Reconnect the battery negative cable.
LAMP - FRONT
NOTE: Two different front dome lamps are available, one for vehicles without a sunroof and a second for vehicles with a sunroof. The only differences between these lamps are that the one for sunroof applications has a mount for a power sunroof switch within the lamp housing, an opening in the center of the lamp lens through which the sunroof switch rocker protrudes, and an opening on the back of the lamp housing through which the sunroof switch connector receptacle protrudes. The lamp and bulb service procedures are the same for either lamp.
1. Position the dome lamp unit (1) to the mounting hole in the headliner.
2. Reconnect the wire harness connector to the connector on the back of the lamp.
3. If the vehicle is equipped with an optional power sunroof, reconnect the wire harness connector to the sunroof switch connector receptacle on the back of the lamp.
4. Insert the fixed retainer on the notched end of the lamp housing up into one side of the mounting hole in the headliner.
5. Slide the notched end of the housing into the mounting hole far enough to engage the lens hinge/retainer (4) into the opposite side of the hole in the headliner.
6. Gently and evenly press the lens hinge/retainer end of the lamp upward into the mounting hole until the bezel of the lamp housing is flush with the headliner.
7. Swing the notched end of the lamp lens (2) up into position against the lamp housing, then press upward on the lens firmly and evenly until it snaps into the housing.
8. Reconnect the battery negative cable.
BULB - REAR
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.
1. Align the ends of the bulb (3) with the two bulb holders within the rear dome lamp housing (1).
2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place.
3. Swing the notched end of the lens (4) up into position against the housing, then press upward on the lens firmly and evenly until it snaps into the housing.
4. Reconnect the battery negative cable.
LAMP - REAR
1. Position the rear dome lamp unit (1) to the mounting hole in the headliner.
2. Reconnect the wire harness connector to the connector on the back of the lamp.
3. Insert the fixed retainer (4) on the notched end of the lamp housing up into one side of the mounting hole in the headliner.
4. Slide the notched end of the housing into the mounting hole far enough to engage the lens hinge/retainer (3) into the opposite side of the hole in the headliner.
5. Gently and evenly press the lens hinge/retainer end of the lamp into the mounting hole until the bezel of the lamp housing is flush with the headliner.
6. Swing the notched end of the lamp lens (2) into position against the lamp housing, then press on the lens firmly and evenly until it snaps into the housing.
7. Reconnect the battery negative cable.