REMOVAL
BULB - FASCIA MOUNTED
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
1. Disconnect and isolate the battery negative cable.
2. Remove the three screws (2) that secure the front fog lamp bezel and lens to the back of the lamp housing (1).
3. Pull the bezel (1) and lens away from the front of the lamp housing far enough to access and disconnect the fog lamp wiring connector from the bulb pigtail wire (2).
4. Pinch together the two hooked ends of the bulb retainer clip (2) and disengage them from the slots (3) in the mounting flange (4) on the back of the lens reflector.
5. Pivot the retainer clip up off of the bulb flange and out of the way.
6. Pull the bulb straight out of the mounting flange on the back of the lens reflector.
BULB - GRILLE MOUNTED
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
1. Disconnect and isolate the battery negative cable.
2. Remove the front fog lamp from the grille opening reinforcement (1), but do not disconnect the wire harness connector (3) from the socket (2) on the back of the lamp housing (4). (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/FRONT FOG LAMP - REMOVAL).
3. Firmly grasp the socket on the back of the housing and rotate it counterclockwise about 30 degrees to unlock it.
4. Pull the socket and bulb straight out from the keyed opening in the housing.
5. Pull the base of the bulb straight out of the socket.
LAMP - FASCIA MOUNTED
1. Disconnect and isolate the battery negative cable.
2. Remove the grille panel from the front of the grille opening reinforcement. (Refer to 23 - BODY/EXTERIOR/GRILLE - REMOVAL).
3. Disconnect the front fog lamp pigtail wire from the connector on the grille opening reinforcement.
4. Remove the screw (1) from the mounting bracket that secures the fog lamp (2) to the bracket on the top of the front bumper fascia.
5. Remove the lamp from the top of the fascia.
LAMP - GRILLE MOUNTED
1. Disconnect and isolate the battery negative cable.
2. Remove the grille panel from the front of the grille opening reinforcement. (Refer to 23 - BODY/EXTERIOR/GRILLE - REMOVAL).
3. Remove the screw (3) that secures the fog lamp adjuster bracket (2) to the grille opening reinforcement (1).
4. Insert a trim stick or another suitable wide flat-bladed tool, between either side of the lamp (4) and the side of the lamp seat in the grille opening reinforcement.
5. Carefully pry the pivot pin on either side of the lamp out of its receptacle in the stanchion within the seat of the reinforcement.
6. Pull the lamp out from the seat far enough to access and disconnect the wire harness connector from the bulb socket on the back of the lamp housing.
7. Remove the lamp from the vehicle.