INSTALLATION
INSTALLATION - LHD
NOTE: On vehicles equipped with a manual transmission, it will be helpful to depress the clutch pedal when installing the Junction Block under the instrument panel.
1. Position the junction block and install the four junction block retaining screws.
2. Install instrument panel wire harness on the lower channel of the instrument panel.
3. Working through the steering column opening cover, install the three bulkhead and two body controller electrical connectors on the junction block assembly.
4. Install the courtesy lamp under the left side of the instrument panel.
5. Install the left cowl trim panel on the vehicle (Refer to 23 - BODY/INTERIOR/COWL TRIM COVER - REMOVAL).
6. Install the steering column opening cover (Refer to 23 - BODY/INSTRUMENT PANEL/STEERING COLUMN OPENING COVER - REMOVAL).
7. Install the left outboard trim bezel on the instrument panel.
8. Install the left end cap on the instrument panel.
9. Connect the negative battery cable.
INSTALLATION - RHD
1. Position the junction block and install the four junction block retaining screws.
2. Install the upper and forward most group of relays in the junction block.
3. Install the two ground wires on the right lower kick panel area.
4. Working through the steering column opening cover, install the three bulkhead and two body controller electrical connectors on the junction block assembly.
5. Install the courtesy lamp under the right side of the instrument panel.
6. Install the right cowl trim panel on the vehicle (Refer to 23 - BODY/INTERIOR/COWL TRIM COVER - INSTALLATION).
7. Install the steering column opening cover (Refer to 23 - BODY/INSTRUMENT PANEL/STEERING COLUMN OPENING COVER - INSTALLATION).
8. Install the right outboard trim bezel on the instrument panel.
9. Install the right end cap on the instrument panel.
10. Connect the negative battery cable.