REMOVAL
BULB
1. Disconnect and isolate the battery negative cable.
2. Remove the front park/turn signal lamp unit (1) from the front fascia. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/PARK/TURN SIGNAL LAMP - REMOVAL).
3. Firmly grasp the park/turn signal bulb socket (2) on the back of the lamp unit housing and rotate it counterclockwise about 30 degrees to unlock it.
4. Pull the socket and bulb (3) straight out from the keyed opening in the housing.
5. Pull the base of the bulb straight out of the socket.
LAMP
1. Disconnect and isolate the battery negative cable.
2. Remove the screw (3) that secures the inboard side of the front park/turn signal lamp unit (1) to the front bumper fascia (4).
3. Pull the inboard side of the lamp (4) away from the fascia far enough to disengage the tab that secures the outboard side of the lamp from the slot (1) in the front bumper fascia.
4. Disengage the lock feature and disconnect the wire harness connector (2) from the lamp socket.
5. Remove the front park/turn signal lamp unit from the vehicle.