INSTALLATION
FRONT PADS
1. Remove and clean all rust and debris from the anti-rattle clip mounting surfaces (3) on the brake caliper adapter (2).
2. Install new anti-rattle clips into the caliper adapter (4).
3. Install the inboard (2) and outboard brake pads (3) onto the caliper adapter (4).
4. Install caliper (4) on the caliper adapter.
5. Install the caliper slide pin bolts (3) and tighten to 44 N·m (32 ft. lbs.).
6. Install wheel and tire assembly.
7. Remove support and lower vehicle.
8. Pump brake pedal until caliper pistons and brake pads are seated and a firm brake pedal is obtained.
9. Fill brake fluid.
REAR DISC BRAKE PADS
1. Bottom pistons in caliper bore with C-clamp. Place an old brake shoe between a C-clamp and caliper piston.
2. Clean caliper mounting adapter and anti-rattle springs.
3. Install anti-rattle springs.
NOTE: Anti-rattle springs are not interchangeable.
4. Install inboard brake pad (3) in adapter (1).
5. Install outboard brake pad (4) in adapter (1).
6. Install caliper, (Refer to 5 - BRAKES/HYDRAULIC/MECHANICAL/DISC BRAKE CALIPERS - INSTALLATION).
7. Install wheel and tire assemblies and lower vehicle, (Refer to 22 - TIRES/WHEELS/WHEELS - STANDARD PROCEDURE).
8. Apply brakes several times to seat caliper pistons and brake pads to obtain firm pedal.
9. Top off master cylinder fluid level.