REGULATOR - REAR DOOR WINDOW
REMOVAL
1. Remove the carrier plate, (Refer to 23 - BODY/DOOR - FULL REAR/CARRIER PLATE - REMOVAL).
NOTE: Front door shown, rear door similar.
2. Remove the screws (1) and disconnect the electrical connector (2).
3. Remove the motor (3).
4. Remove the rail screws (2) and separate the lift regulator (3) from the carrier plate (1).
INSTALLATION
NOTE: Front door shown, rear door similar.
1. Position the regulator (3) onto the carrier plate (1) and install the screws (2).
NOTE: Front door shown, rear door similar.
2. Install the motor (3) and install the screws (1).
3. Connect the electrical connector (2).
4. Install the carrier plate, (Refer to 23 - BODY/DOOR - FULL REAR/CARRIER PLATE - INSTALLATION).