COVER-ENGINE - FRONT
DESCRIPTION
The oil pump cover assembly on this engine is an aluminum cover that incorporates the oil pump.
REMOVAL
1. Disconnect negative battery cable.
2. Remove cooling fan and fan drive viscous clutch assembly (Refer to 7 - COOLING/ENGINE/FAN DRIVE VISCOUS CLUTCH - REMOVAL) .
3. Remove accessory drive belt (Refer to 7 - COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
4. Remove the timing belt. (Refer to 9 - ENGINE/VALVE TIMING/TIMING BELT/CHAIN AND SPROCKETS - REMOVAL)
NOTE: The crankshaft sprocket bolt is a left handed thread.
5. Remove the crankshaft sprocket.
6. Remove the high pressure pump (5) sprocket.
7. Remove the oil pump cover assembly.
INSTALLATION
1. Remove the oil pump cover assembly.
2. Install the high pressure pump (5) sprocket.
NOTE: The crankshaft sprocket bolt is a left handed thread.
3. Install the crankshaft sprocket.
4. Install the timing belt. (Refer to 9 - ENGINE/VALVE TIMING/TIMING BELT/CHAIN AND SPROCKETS - REMOVAL)
5. Install the cooling fan and fan drive viscous clutch assembly
6. Install the accessory drive belt
7. Connect negative battery cable.