LIFTERS-HYDRAULIC
DESCRIPTION
Valve lash is controlled by hydraulic tappets (2) located inside the cylinder head, in tappet bores below the camshafts.
REMOVAL
1. Remove the cylinder head cover. (Refer to 9 - ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S) - REMOVAL)
2. Remove the camshafts. (Refer to 9 - ENGINE/CYLINDER HEAD/CAMSHAFT(S) - REMOVAL)
NOTE: Always return the hydraulic lifters to their original location in the cylinder head.
3. Remove the rocker arms (1) and hydraulic lifters (2).
INSPECTION
Clean each lifter assembly (1) in cleaning solvent to remove all varnish and sludge deposits. Inspect for indications of scuffing on the side and base of each lifter body.
INSTALLATION
1. Install the rocker arms (1) and hydraulic lifters (2) into their original locations.
2. Remove the camshafts. (Refer to 9 - ENGINE/CYLINDER HEAD/CAMSHAFT(S) - REMOVAL)
3. Remove the cylinder head cover. (Refer to 9 - ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S) - REMOVAL)