CENTER BEZEL
REMOVAL
1. Using a trim stick C-4755 or equivalent, release the clips (2) and rotate the lower center trim (3) down and release the tabs (1).
2. Using a trim stick C-4755 or equivalent (2), release the clips in the rear of the upper trim (1).
3. Rotate the upper trim (2) back and release the front (1).
4. Disconnect the electrical connector (4) and remove the upper center cover (1).
5. Remove the screws (2) and using a trim stick C-4755 or equivalent, separate the center bezel (1).
6. Disconnect the HVAC control cables (1 and 9) and disconnect the electrical connectors (3).
7. Remove the screws (2) and remove the center I/P trim panels (1 and 3).
INSTALLATION
1. Install the center I/P trim panels (1 and 3) and install the screws (2).
2. Install the radio, (Refer to 8 - ELECTRICAL/AUDIO/RADIO - INSTALLATION).
3. Connect the HVAC control cables (1 and 9) and connect the electrical connectors (3 and 4).
4. Position the center bezel (1) onto the I/P and seat the clips fully.
5. Install the lower screws (2).
6. Connect the electrical connector (4) and position the upper center cover onto the top of the I/P.
7. Position the front of the cover (1) onto the center support and rotate the trim (2) back and seat the clips fully.
8. Position the lower tabs (1) into the slots and rotate the trim (3) up and seat the clips (2) fully.