2007 Wrangler JK Factory Service Manual Not in the contents tree

2.8L–DIESEL

1. Install the pump to the vehicle.
2. Install the three bolts (2) securing the pump (1) to the engine and tighten to 26 N·m (19 ft. lbs.)..

3. Install the power steering hoses (1&6). Tighten to 31 N·m (23 ft. lbs.).
4. Install the power steering pulley to the pump.
5. Install the three bolts (4) securing the pulley (3) to the pump (2).
6. Install the serpentine belt.

7. Install the air inlet tube (1).
8. Install the air cleaner box (Refer to 9 - ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - INSTALLATION).
9. Refill the power steering fluid and bleed the system (Refer to 19 - STEERING - STANDARD PROCEDURE).