B1A26–MAXIMUM NUMBER OF KEYS PROGRAMMED

For a complete wiring diagram Refer to Section 8W.

When Monitored:
With the ignition on.
Set Condition:
When the maximum number of keys (8) have been programmed into the Sentry Key Remote Entry Module (SKREEM).

MAXIMUM AMOUNT OF KEY PROGRAMMED INTO SKREEM

Diagnostic Test

NOTE: This procedure will clear all the key information from the SKREEM. It is important to obtain all of the customer's ignition keys so they may be reprogrammed into the module.

Turn the ignition on.
With the scan tool, clear all the key information in the SKREEM.
Program the all of the customer keys into the SKREEM (maximum eight).

Did the “Maximum Number of Keys Programmed” display again?

Yes

Replace and program the SKREEM in accordance with the Service Information.

NOTE: If this vehicle is equipped with a Steering Column Lock Module it must be replaced along with the SKREEM.

Perform SKREEM VERIFICATION TEST. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE).

Programming of the keys was successful. Test complete.
Perform SKREEM VERIFICATION TEST. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE).