B2204-ECU CONFIGURATION MISMATCH
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on.
| Possible Causes |
| SENTRY KEY REMOTE ENTRY MODULE (SKREEM) |
Diagnostic Test
1. VERIFY THAT THE DTC IS ACTIVETurn the ignition on.
NOTE:
Before continuing, review and check for the following:
With the scan tool, clear DTCs.
Perform 5 ignition cycles, leaving the ignition switch on for a minimum of 90 seconds per cycle.
With the scan tool, read DTCs.
Does the DTC reset?
Yes
- Replace and program the SKREEM in accordance with the Service Information.
NOTE: If this vehicle is equipped with a Steering Column Lock Module, it must be replaced along with the SKREEM.
- Perform SKREEM VERIFICATION TEST. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE)
No
- The DTC is not active at this time. Test complete.