B2206-CURRENT VIN MISSING / MISMATCH
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on.
- Set Condition:
A PCM from another vehicle has been installed in the vehicle.
| Possible Causes |
| PCM FROM ANOTHER VEHICLE INSTALLED |
Diagnostic Test
1. PCM FROM ANOTHER VEHICLE INSTALLEDNOTE: When this DTC is set when a PCM from another vehicle is installed into the current vehicle.
Has another PCM been installed?
Yes
- Replace the PCM in accordance with the service information.
- Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Go To 2
2. OTHER CAN-C MODULES SET VIN MISMATCH
Is VIN Mismatch DTC set in other CAN-C modules?
Yes
- Replace the PCM in accordance with the service information.
- Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Replace the TIPM in accordance with the service information.
- Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)