B2215–FCM INTERNAL (TIPM)
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
Continuously.
- Set Condition:
The TIPM detects an internal fault.
| Possible Causes |
| TIPM |
Diagnostic Test
1. TIPMTurn the ignition on.
With the scan tool, read DTCs.
Does the scan tool display this DTC as active?
Yes
- Go To 2
No
- Test complete.
2. TIPM
With the scan tool, clear DTCs.
Does the DTC clear?
Yes
- Test complete.
No
- Replace the TIPM in accordance with the service information.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)