INSTALLATION
1. Position exhaust manifold on cylinder head and install bolts to center runner (cylinder # 3) and initial tighten to 2.8 N·m (25 in. lbs.).
2. Install the remaining manifold attaching bolts. Tighten all bolts to 23 N·m (200 in. lbs.).
3. Install and connect upstream oxygen sensor.
4. Connect the spark plug wires to the spark plugs.
5. Connect the IAC,TPS and the EVAP hose to the throttle body.
6. Install the air cleaner housing.
7. Raise the vehicle.
8. Attach exhaust pipe to exhaust manifold using new gasket and tighten bolts to 37 N·m (27 ft. lbs.)
9. Connect battery negative cable.