2007 Wrangler JK Factory Service Manual Not in the contents tree

INSTALLATION




1. Position the intrusion module (3) and mounting bracket (4) under the instrument panel as a unit.
2. Reconnect the instrument panel wire harness connector to the connector receptacle at the forward-facing of the module housing.
3. Position the module mounting bracket to the lower instrument panel reinforcement (2).
4. Install and tighten the two screws (1) that secure the mounting bracket to the lower instrument panel reinforcement. Tighten the screws to 8 N·m (71 in. lbs.).
5. Reinstall the steering column opening cover onto the instrument panel. (Refer to 23 - BODY/INSTRUMENT PANEL/STEERING COLUMN OPENING COVER - INSTALLATION).
6. Reconnect the battery negative cable.