2007 Wrangler JK Factory Service Manual Not in the contents tree

LAMP




1. Position the cargo lamp unit (1) to the mounting hole in the sport bar trim.
2. Reconnect the wire harness connector to the connector receptacle on the back of the lamp housing.
3. Insert the fixed retainer (4) on the notched end (5) of the lamp housing up into the right side of the mounting hole in the sport bar trim.
4. Slide the notched end of the housing into the mounting hole far enough to engage the lens hinge/retainer (3) into the opposite side of the hole in the sport bar trim.
5. Gently and evenly press the lens hinge/retainer end of the lamp into the mounting hole until the bezel of the lamp housing is flush with the sport bar trim.
6. Swing the notched end of the lamp lens (2) into position against the lamp housing, then press on the lens firmly and evenly until it snaps into the housing.
7. Reconnect the battery negative cable.