2007 Wrangler JK Factory Service Manual Not in the contents tree

LAMP




1. Position the dome lamp unit (1) to the mounting hole in the rear speaker enclosure.
2. Reconnect the wire harness connector to the connector on the back of the lamp.
3. Insert the fixed retainer (4) on the notched end (5) of the lamp housing up into the right side of the mounting hole in the speaker enclosure.
4. Slide the notched end of the housing into the mounting hole far enough to engage the lens hinge/retainer (3) into the opposite side of the mounting hole in the speaker enclosure.
5. Gently and evenly press the lens hinge/retainer end of the lamp into the mounting hole until the bezel of the lamp housing is flush with the speaker enclosure.
6. Swing the notched end of the lamp lens (2) into position against the lamp housing, then press on the lens firmly and evenly until it snaps into the housing.
7. Reconnect the battery negative cable.