2007 Wrangler JK Factory Service Manual Not in the contents tree

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the steering column opening cover from the instrument panel. (Refer to 23 - BODY/INSTRUMENT PANEL/STEERING COLUMN OPENING COVER - REMOVAL).
3. Remove the two screws (1) that secure the intrusion module mounting bracket (4) to the lower instrument panel reinforcement (2).
4. Lower the intrusion module (3) and mounting bracket from the instrument panel reinforcement far enough to access and disconnect the instrument panel wire harness connector from the connector receptacle at the forward-facing end of the module housing.
5. Remove the module and mounting bracket from under the instrument panel as a unit.