P2167-ACCELERATOR PEDAL POSITION SENSOR 2 MAXIMUM STOP PERFORMANCE
P2167-ACCELERATOR PEDAL POSITION SENSOR 2 MAXIMUM STOP PERFORMANCE
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
With the igniting on. During in-plant testing, the APP Sensors need to be checked to make sure the minimum and maximum values can be reached.
-
Set Condition:
APPS 2 has failed to achieve the required maximum value during In-Plant testing. One trip fault and the code will be stored within five seconds. Engine will only idle.
POSSIBLE CAUSES |
|---|
| ETC RELEARN |
| ACCELERATOR PEDAL POSITION SENSOR |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
| NOTE: | This DTC is set when the APP Sensor values are learned in-plant but do not reach the minimum or maximum voltage range. |
| NOTE: | Diagnose any APPS out of range and 5 volt supply DTCs before continuing. |
| 1. | Start the engine and allow it to reach normal operating temperature. |
When the engine is operating, do
not stand in direct line with the fan. Do not put your hands near
the pulleys, belts or fan. Do not wear loose clothing. Failure to
follow these instructions may result in possible serious or fatal
injury.
WARNING:
| 2. | With the scan tool, select View DTCs. |
Is the status Active for this DTC?
Yes
- Go To 2
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
2. ACCELERATOR PEDAL POSITION SENSOR
| 1. | With a scan tool perform the ETC RELEARN function. |
| 2. | With the scan tool, clear DTCs. |
| 3. | Start the engine. |
| 4. | With the scan tool, select View DTCs. |
Is the status Active for this DTC?
Yes
- Replace the Accelerator Pedal Position Sensor in accordance with the Service Information. After installation is complete, perform the ETC RELEARN function.
- Perform the PCM Verification Test. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
No