U0416-IMPLAUSIBLE DATA RECEIVED FROM ESP
U0416-IMPLAUSIBLE DATA RECEIVED FROM ESP
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
Continuously while the system is active.
-
Set Condition:
Implausible data has been received over the bus from the Electronic Stability Program (ESP) in the ABS Module.
Possible Causes |
|---|
| CAN BUS OPEN OR SHORTED CONDITION |
| ELECTRONIC STABILITY PROGRAM (ESP)/ANTILOCK BRAKE MODULE (ABS) |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
| NOTE: | Diagnose all CAN communication DTCs before continuing. |
| 1. | Turn the ignition on. |
| 2. | With a scan tool, view DTCs. |
Is the status Active for this DTC?
Yes
- Go To 2
No
- (Refer to 29 - Non-DTC Diagnostics/Communication - Diagnosis and Testing) and perform the Stored Lost Communication DTCs diagnostic procedure.
2. ABS COMMUNICATION RELATED DTCs IN OTHER MODULES
| 1. | With a scan tool check for ABS communication related DTCs in other modules on the CAN Bus. |
Are there any ABS communication related DTCs in other modules on the CAN Bus at this time?
Yes
- Replace and program the Anti-lock Brake Module (ABM) in accordance with the service information.
- Perform the PCM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
No
- Replace and program the Powertrain Control Module (PCM) in accordance with the service information.
- Perform the PCM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).