2014 Jeep Wrangler JK Factory Service Manual 28 - DTC-Based Diagnostics

C2206-VEHICLE CONFIGURATION MISMATCH

For a complete wiring diagram, refer to the Wiring Information.

When Monitored:
With the ignition on.
Set Condition:
When the Anti-lock Brake (ABS) Module detects the signal from the gateway module relevant for vehicle characteristic is missing for a period greater than the specified fault duration.

Possible Causes
VEHICLE CONFIGURATION MISMATCH
ABS MODULE INITIALIZATION
ANTI-LOCK BRAKE SYSTEM (ABS) MODULE

1. VERIFY THE DTC IS ACTIVE

1.	Turn the ignition on.

2.	With the scan tool, select "Miscellaneous Functions" and Restore Vehicle Configuration.

3.	With the scan tool, record and erase the DTCs.

4.	Cycle the ignition switch off then on.

5.	With the scan tool, read the DTCs.

Is the DTC active at this time?

Yes

Go To 2

No

Perform the ABS VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure).

2. INITIALIZE THE ABS MODULE

1.	Cycle the ignition switch off then on.

2.	With the scan tool, under "Miscellaneous Functions" run the ABS Initialization routine.

3.	With the scan tool, erase the DTCs.

4.	With the scan tool, read the DTCs.

Does the DTC remain active?

Yes

Replace the Anti-lock Brake System (ABS) Module in accordance with the service information. (Refer to 08 - Electrical/8E - Electronic Control Modules/MODULE, Anti-Lock Brake System - Removal) .
Perform the ABS VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure).

No

Test complete, the condition or conditions that originally set this DTC are not present at this time.