2014 Jeep Wrangler JK Factory Service Manual 05 - Brakes, Base

LEVER, Parking Brake

REMOVAL

  1. Remove the center console (3) (Refer to 23 - Body/Interior/CONSOLE, Center - Removal) .

    2.  
  2. Lockout the parking brake lever by inserting a punch (1) in the hole on the lever and by pulling up on the cable (3) to loosen and provide some slack (Refer to 05 - Brakes/Parking Brake - Standard Procedure) .

    3.  
  3. Disconnect the rear park cables (2) from the equalizer.

    4.  
  4. Disconnect the electrical connector (4).

    5.  
  5. Disconnect the electrical wiring harness clip (5) on the side of the lever.

    6.  
  6. Remove the four mounting nuts (2) for the park brake lever.

    7.  
  7. Remove the lever from the vehicle.

    8.  

INSTALLATION

  1. Install the lever to the vehicle.

    2.  
  2. Install the four mounting nuts (2) and tighten the nuts to

    3.  
  3. Reconnect the electrical wiring clip (5) to the side of the lever.

    4.  
  4. Reconnect the electrical connector (4) to the lever.

    5.  
  5. Reconnect the equalizer (2) to the rear park brake cables.

    6.  
  6. Remove the lockout (1) for the park brake lever.

    7.  
  7. Check park brake system operation.

    8.  
  8. Install the center console (3) (Refer to 23 - Body/Interior/CONSOLE, Center - Installation) .

    9.