Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID BATTERY SYSTEM

HYBRID BATTERY SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



Data List

NOTICE:
  1. Some Data List values may vary significantly if there are slight differences in the environment in which the vehicle is operating when measurements are obtained. Variations may also occur due to aging of the vehicle. Due to these considerations, it is not always possible to provide definite values to be used for judgment of malfunctions. It is possible that a malfunction may be present even if measured values are within the reference range.
  2. In the event of a problem with intricate symptoms, collect sample data from another vehicle of the same model operating under identical conditions in order to reach an overall judgment by comparing all the items in the Data List.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Enter the following menus: Powertrain / Hybrid Control / Data List.

  4. Check the results by referring to the following table.

    HINT:
    For the data list, Click here.


Active Test
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data list information can be displayed while performing Active Tests.

NOTICE:
It is necessary to use caution, because if the tester DLC connector becomes disconnected or if a communication error occurs during an Active Test, the vehicle could become inoperative (the READY indicator may go off).

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.
    Enter the following menus: Powertrain / Hybrid Control / Active Test.

  4. According to the display on the intelligent tester perform the appropriate Active Test.

    HINT:
    For the active test chart, Click here.