Lexus IS250 · Service Manual ENGINE

REMOVAL

Removal / installation


1. REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)

HINT:
Click here.


2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

HINT:
Click here.


3. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

  1. A108859E01
    Using SST, hold the crankshaft.
    SST
    09213-70011   (09213-70020)
    09330-00021  

  1. A125556
    Remove the 8 bolts and the flywheel.


4. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

  1. A108859E01
    Using SST, hold the crankshaft.
    SST
    09213-70011   (09213-70020)
    09330-00021  

  1. A108862
    Remove the 8 bolts, front spacer, drive plate and rear spacer.


5. REMOVE ENGINE REAR OIL SEAL

  1. A094672E01
    Using a knife, cut through the oil seal lip.

  1. Using a screwdriver with its tip taped, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

← COMPONENTSINSTALLATION →