Lexus IS250 · Service Manual DRIVE LINE

REMOVAL

Removal / installation


1. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)

2. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

  1. C125771E01
    Remove the 4 nuts and front No. 1 floor heat insulator.


3. REMOVE OUTSIDE AIR GUIDE PLATE RH

  1. C126031
    Remove the 4 nuts and outside air guide plate RH.


4. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

  1. C104521E02
    Put matchmarks on both flanges.

  1. Remove the 4 nuts, bolts and washers.

    HINT:
    If the flange connection is hard to separate, temporarily tighten one nut only and evenly tap the flange with a brass bar and hammer to separate the propeller shaft assembly from the differential companion flange.

  1. F048233
    Remove the 2 bolts and 2 center support bearing washers. (for automatic transmission)

  1. Remove the 2 bolts, 2 center support bearing washers and 2 center support bearing dampers. (for manual transmission)

  1. Separate the center support bearing.

  1. C109590E02
    Insert SST in the transmission to prevent oil leakage.
    SST
    09325-40010  

    NOTICE:
    Be careful not to damage the oil seal.

← COMPONENTSDISASSEMBLY →