PROBLEM SYMPTOMS TABLE
Troubleshooting
- HINT:
- Be sure to perform the SYMPTOM SIMULATION procedure before replacing the ECM. If these symptoms do not persist, the cause of the problem may be a poor intermittent electrical contact (open or short) of a wire harness or connector.
| Symptom |
Suspected area |
See page |
| Vehicle speed cannot be set. (The CRUISE main indicator light comes on.) |
1. Cruise control switch circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| Pushing the ON-OFF button does not turn the cruise control system on. (Vehicle speed cannot be set.) |
1. Stop light switch circuit |
Click here
|
| 2. Clutch switch circuit |
Click here
|
|
| 3. Vehicle speed sensor circuit |
Click here
|
|
| 4. Cruise control switch circuit |
Click here
|
|
| 5. Park/Neutral position sensor circuit |
Click here
|
|
| 6. Shift paddle switch circuit |
Click here
|
|
| 7. If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM. |
Click here
|
|
| Pushing the ON-OFF button does not turn the cruise control system on. (Vehicle speed can be set.) |
1. Cruise main indicator light circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| The cruise control is canceled while it is operating. |
1. Stop light switch circuit |
Click here
|
| 2. Clutch switch circuit |
Click here
|
|
| 3. Park/Neutral position sensor circuit |
Click here
|
|
| 4. Shift paddle switch circuit |
Click here
|
|
| 5. Cruise control switch circuit |
Click here
|
|
| 6. Vehicle speed sensor circuit |
Click here
|
|
| 7. If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM. |
Click here
|
|
| Pulling back on the control main switch does not cancel the cruise control. (The CRUISE main indicator light remains on.) |
1. Cruise control switch circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| Pulling back on the control main switch does not cancel the cruise control. (The CRUISE main indicator light goes off.) |
1. ECM |
Click here
|
| The cruise control is not canceled when vehicle speed drops below the low speed limit. (The CRUISE main indicator light remains on.) |
1. Vehicle speed sensor circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| The cruise control is not canceled when vehicle speed drops below the low speed limit. (The CRUISE main indicator light goes off.) |
1. ECM |
Click here
|
| Depressing the brake pedal does not cancel the cruise control. (The CRUISE main indicator light remains on.) |
1. Stop light switch circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| Depressing the brake pedal does not cancel the cruise control. (The CRUISE main indicator light goes off.) |
1. ECM |
Click here
|
| Depressing the clutch pedal does not cancel the cruise control. (The CRUISE main indicator light remains on.) |
1. Clutch switch circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| Depressing the clutch pedal does not cancel the cruise control. (The CRUISE main indicator light goes off.) |
1. ECM |
Click here
|
| Depressing the clutch pedal does not cancel the cruise control. (The CRUISE main indicator light goes off) |
1. ECM |
Click here
|
| Moving the shift lever does not cancel the cruise control. |
1. Park/Neutral position switch circuit |
Click here
|
| 2. Shift paddle switch circuit |
Click here
|
|
| 3. If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM. |
Click here
|
|
| Hunting. (Speed is not constant.) |
1. Vehicle speed sensor circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| The CRUISE main indicator light remains blinking. |
1. TC and CG terminal circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|