Illumination for Panel Switch does not Come on with Tail Switch ON

INSPECTION PROCEDURE

1. CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)

1. Enter the "Display Check" mode (Vehicle Signal Check Mode) (Click here).

2. Check that the display changes between ON and OFF according to the light control switch operation.

   OK:

   Light Control Switch	Display
   TAIL or ON	ON
   OFF	OFF

   HINT:

   This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.

NG	PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

OK
REPLACE MULTI-DISPLAY