Lexus IS250 · Service Manual ENGINE

REMOVAL

Removal / installation


1. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A127528
    Raise the V-bank cover to disengage the clip on the rear of the cover. Raise the cover again to disengage the 2 clips on the front of the cover and remove the cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.


2. REMOVE VVT SENSOR (for Intake Side of Bank 1)

  1. A119998
    Disconnect the sensor connector.

  1. Remove the bolt and sensor.


3. REMOVE VVT SENSOR (for Exhaust Side of Bank 1)

  1. A119999
    Disconnect the sensor connector.

  1. Remove the bolt and sensor.


4. REMOVE VVT SENSOR (for Intake Side of Bank 2)

  1. A120001
    Disconnect the sensor connector.

  1. Remove the bolt and sensor.


5. REMOVE VVT SENSOR (for Exhaust Side of Bank 2)

  1. A120000
    Disconnect the sensor connector.

  1. Remove the bolt and sensor.

← ON-VEHICLE INSPECTIONINSTALLATION →