INSPECTION

Inspection

INSPECT POWER WINDOW REGULATOR MOTOR (FRONT RH)

1. Apply battery voltage to the motor connector according to the table below.
   

   NOTICE:

   Do not apply battery voltage to any terminals except terminals 1 and 2.

   Standard:

   Measurement Condition	Specified Condition
   Battery positive (+) → Terminal 1 (D) Battery negative (-) → Terminal 2 (U)	Motor gear rotates clockwise
   Battery positive (+) → Terminal 2 (U) Battery negative (-) → Terminal 1 (D)	Motor gear rotates counterclockwise

INSPECT POWER WINDOW REGULATOR MOTOR (FRONT LH)

1. Apply battery voltage to the motor connector according to the table below.
   

   NOTICE:

   Do not apply battery voltage to any terminals except terminals 1 and 2.

   Standard:

   Measurement Condition	Specified Condition
   Battery positive (+) → Terminal 2 (U) Battery negative (-) → Terminal 1 (D)	Motor gear rotates clockwise
   Battery positive (+) → Terminal 1 (D) Battery negative (-) → Terminal 2 (U)	Motor gear rotates counterclockwise

INSPECT POWER WINDOW REGULATOR NOTOR (REAR RH)

1. Apply battery voltage to the motor connector according to the table below.
   

   NOTICE:

   Do not apply battery voltage to any terminals except terminals 1 and 2.

   Standard:

   Measurement Condition	Specified Condition
   Battery positive (+) → Terminal 2 (U) Battery negative (-) → Terminal 1 (D)	Motor gear rotates clockwise
   Battery positive (+) → Terminal 1 (D) Battery negative (-) → Terminal 2 (U)	Motor gear rotates counterclockwise

INSPECT POWER WINDOW REGULATOR MOTOR (REAR LH)

1. Apply battery voltage to the motor connector according to the table below.
   

   NOTICE:

   Do not apply battery voltage to any terminals except terminals 1 and 2.

   Standard:

   Measurement Condition	Specified Condition
   Battery positive (+) → Terminal 1 (D) Battery negative (-) → Terminal 2 (U)	Motor gear rotates clockwise
   Battery positive (+) → Terminal 2 (U) Battery negative (-) → Terminal 1 (D)	Motor gear rotates counterclockwise