58-43

DESCRIPTION

DTC No.	DTC Detection Condition	Trouble Area
58-43	A difference between the GPS speed and SPD pulse is detected.	Speed signal circuit Navigation ECU
80-43	A difference between the GPS speed and SPD pulse is detected.

INSPECTION PROCEDURE

HINT:

After the inspection is completed, clear the DTCs.

1. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

1. Enter the "Navigation Check" mode (Vehicle Sensors) (Click here).

2. While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.

   OK:

   The readings are almost equal.
   

OK	REPLACE NAVIGATION ECU

NG

2. PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

Refer to "Speed signal does not change in the navigation check mode" in the problem symptoms table.

NEXT
END