INSTALLATION
Removal / installation
| 1. INSTALL AMPLIFIER ANTENNA ASSEMBLY |
Engage the clip as shown in the illustration to temporarily install the amplifier antenna assembly.
- NOTICE:
- Clean the antenna conductors on the rear window with white gasoline where the contact terminals will touch.
- When installing a new amplifier antenna assembly, do not remove the protective cover until immediately before installation.
- Do not touch the contact terminals.
- Clean the antenna conductors on the rear window with white gasoline where the contact terminals will touch.
Install the 2 nuts and amplifier antenna assembly.
- Torque:
- 14 N*m{ 143 kgf*cm , 10 ft.*lbf }
Connect the connector.
Engage the clamp.
| 2. INSTALL ROOF HEADLINING ASSEMBLY |
- HINT:
- Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY".
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. PERFORM INITIALIZATION INITIALIZATION |
- NOTICE:
- Some systems need initialization when disconnecting the cable from the negative battery terminal (Click here).
| 5. INSPECT SRS WARNING LIGHT |