| Last Modified: 11-27-2007 | 1.6 G | |
| Service Category: Drivetrain | Section: Axle/Differential | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000001IWW01EX |
| Title: AXLE AND DIFFERENTIAL: FRONT AXLE HUB: ON-VEHICLE INSPECTION (2008 LX570) | ||
ON-VEHICLE INSPECTION
1. REMOVE FRONT WHEEL
2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
3. REMOVE FRONT DISC
4. REMOVE FRONT AXLE HUB GREASE CAP LH
5. INSPECT FRONT AXLE HUB BEARING LOOSENESS
|
(a) Using a dial indicator, measure the looseness near the center of the axle hub. Maximum looseness: 0.05 mm (0.00197 in.) NOTICE:
Ensure that the dial indicator is set at a right angle to the measurement surface. If the looseness is more than the maximum, replace the axle hub. |
6. INSPECT FRONT AXLE HUB RUNOUT
|
(a) Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolt. Maximum runout: 0.08 mm (0.00315 in.) NOTICE:
Ensure that the dial indicator is set at a right angle to the measurement surface. If the runout is more than the maximum, replace the axle hub. |
7. INSTALL FRONT AXLE HUB GREASE CAP LH
8. INSTALL FRONT DISC
9. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
10. INSTALL FRONT WHEEL
Torque: 131 N·m (1336 kgf·cm, 97 ft·lbf)
|
|