| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Brake | Section: Brake Control/Dynamic Control System | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000001WYV00PX |
| Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: SKID CONTROL BUZZER: INSTALLATION (2008 LX570) | ||
INSTALLATION
1. INSTALL SKID CONTROL BUZZER ASSEMBLY
|
(a) Connect the buzzer connector. NOTICE:
Securely connect the connector. |
(b) Attach the clamp to install the buzzer.
NOTICE:
- Securely insert the clamp into the bracket.
- If the buzzer is dropped, replace it.
2. INSTALL NO. 1 SWITCH HOLE BASE
3. INSTALL INSTRUMENT SIDE PANEL
4. INSTALL INSTRUMENT PANEL BOX ASSEMBLY
5. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
6. INSTALL COWL SIDE TRIM BOARD LH
7. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
8. INSTALL FRONT DOOR SCUFF PLATE LH
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
|
|