| Last Modified: 11-27-2007 | 1.6 G | |
| Service Category: Suspension | Section: Tire Pressure Monitoring | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002AS900BX |
| Title: TIRE / WHEEL: TIRE AND WHEEL SYSTEM: INSPECTION (2008 LX570) | ||
INSPECTION
1. INSPECT TIRE
(a) Check the tires for wear and proper inflation pressure.
Standard Cold Tire Inflation Pressure:
|
Tire Size |
Front kPa (kgf/cm2, psi) |
Rear kPa (kgf/cm2, psi) |
|---|---|---|
|
P285/60R18 |
230 (2.3, 33) |
230 (2.3, 33) |
|
P285/50R20 |
230 (2.3, 33) |
230 (2.3, 33) |
|
240 (2.4, 35) * |
* : When towing the vehicle
|
(b) Using a dial indicator, check the tire runout. Tire runout: 3.0 mm (0.118 in.) or less |
2. ROTATE TIRE
HINT:
Rotate the tires as shown in the illustration.
3. INSPECT WHEEL BALANCE
|
(a) Check and adjust the off-the-car balance. |
(b) If necessary, check and adjust the on-the-car balance.
Standard Imbalance After Adjustment:
|
Wheel Size |
Balance Weight |
|---|---|
|
18 x 8J |
7.0 g (0.0154 lb) or less |
|
20 x 8 1/2J |
6.5 g (0.0143 lb) or less |
NOTICE:
-
Using a cleaning detergent, remove dirt, oil and water from the areas shown in the illustration.
- Do not touch the adhesive part of the balance weight.
- Adhere the balance weight to the areas shown in the illustration.
- Push the balance weight securely with your fingers to attach it.
- Do not reuse the balance weight.
- Use up to 2 balance weights on each side (a maximum of 4 balance weights on a wheel).
- When using 2 balance weights on one side, select a pair that have the smallest difference in weight.
4. INSPECT FRONT AXLE HUB
(a) Inspect the front axle hub
.
5. INSPECT REAR AXLE SHAFT
(a) Inspect the rear axle shaft
.
|
|