| Last Modified: 11-27-2007 | 1.6 G | |
| Service Category: Engine/Hybrid System | Section: Lubrication | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002MQJ00GX |
| Title: 3UR-FE LUBRICATION: LUBRICATION SYSTEM: ON-VEHICLE INSPECTION (2008 LX570) | ||
ON-VEHICLE INSPECTION
1. CHECK OIL QUALITY
(a) Check the oil for deterioration, water contamination, discoloring or thinning.
If the quality is visibly poor, replace the oil and filter
.
2. INSPECT ENGINE OIL LEVEL
(a) Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipstick low level mark and full level mark.
If low, check for leakage and add oil up to the full level mark.
NOTICE:
Do not fill engine oil above the full level mark.
3. INSPECT OIL PRESSURE
(a) Remove the oil pressure sender gauge
.
|
(b) Install an oil pressure gauge with an adapter. |
(c) Warm up the engine.
(d) Measure the engine oil pressure.
Standard Oil Pressure:
|
Condition |
Specified Condition |
|---|---|
|
Idle |
70 kPa (0.7 kgf/cm2, 10.1 psi) or higher |
|
2500 rpm |
220 kPa (2.2 kgf/cm2, 32 psi) or higher |
If the pressure is not as specified, check the oil pump
.
(e) Remove the oil pressure gauge and adapter.
(f) Install the oil pressure sender gauge
.
|
|