Home › Engine/Hybrid System › Lubrication › 3UR-FE LUBRICATION: OIL PRESSURE SENSOR
Last Modified: 11-27-2007 1.6 A
Service Category: Engine/Hybrid System Section: Lubrication
Model Year: 2008 Model: LX570 Doc ID: RM000002RTF00FX
Title: 3UR-FE LUBRICATION: OIL PRESSURE SENSOR: INSTALLATION (2008 LX570)

INSTALLATION

1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

(a) Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

NOTICE:

Do not allow adhesive to contact the oil hole.

(b) Install the oil pressure sender gauge.

Torque: 15 N·m (153 kgf·cm, 11 ft·lbf)

NOTICE:

Do not start the engine within 1 hour after installation.

(c) Connect the sender gauge connector.

2. ADD ENGINE OIL 3UR-FE LUBRICATION: OIL AND OIL FILTER: REPLACEMENT (2008 LX570)+

3. INSPECT FOR OIL LEAK 3UR-FE LUBRICATION: OIL AND OIL FILTER: REPLACEMENT (2008 LX570)+

4. INSPECT ENGINE OIL LEVEL 3UR-FE LUBRICATION: LUBRICATION SYSTEM: ON-VEHICLE INSPECTION (2008 LX570)+

5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 LX570)+

6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION (2008 LX570)+

7. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION (2008 LX570)+