|
Last Modified: 11-27-2007 |
1.6 A |
|
Service Category: Vehicle Interior |
Section: Supplemental Restraint Systems |
|
Model Year: 2008 |
Model: LX570 |
Doc ID: RM000002OEU007X |
|
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Front Passenger Side): INSTALLATION (2008 LX570) |
INSTALLATION
1. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
|
(a) Connect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
|
(b) Attach the 4 claws to install the front passenger side knee airbag.
(c) Install the 4 bolts.
Torque: 10 N·m (102 kgf·cm, 7 ft·lbf)
2. INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH
3. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
5. INSTALL COWL SIDE TRIM BOARD RH
6. INSTALL FRONT DOOR SCUFF PLATE RH
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
8. INSTALL ENGINE ROOM SIDE COVER LH
9. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light
.
|