Home Vehicle Interior Supplemental Restraint Systems REAR AIRBAG SENSOR
Last Modified: 11-27-2007 1.6 A
Service Category: Vehicle Interior Section: Supplemental Restraint Systems
Model Year: 2008 Model: LX570 Doc ID: RM000002OF6007X
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: REAR AIRBAG SENSOR: INSTALLATION (2008 LX570)

INSTALLATION

HINT:

  • Use the same procedures for the LH side and RH side.
  • The procedures listed below are for the LH side.

1. INSTALL REAR AIRBAG SENSOR


(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Install the rear airbag sensor with the bolt.

Torque: 9.0 N·m (92 kgf·cm, 80 in·lbf)

NOTICE:

  • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
  • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the rear airbag sensor.

(e) Connect the connector.

2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

3. INSTALL REAR SEAT COVER CAP (for Semi Power Seat) INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

4. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

5. INSTALL REAR DOOR SCUFF PLATE LH INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

6. INSTALL REAR STEP COVER INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

7. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

8. INSTALL REAR NO. 2 SEAT ASSEMBLY LH

(a) Install the rear No. 2 seat assembly SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Automatic Folding-up Function): INSTALLATION (2008 LX570) .

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

10. INSTALL ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+

11. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: DIAGNOSIS SYSTEM (2008 LX570) .