| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Seat | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM00000391Q002X |
| Title: SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Automatic Folding-up Function): INSTALLATION (2008 LX570) | ||
INSTALLATION
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. INSTALL FOLD SEAT SWITCH ASSEMBLY
(a) Attach the claw to install the light.
(b) Connect the connector.
|
(c) Attach the 6 clips to install the fold seat switch. |
2. INSTALL REAR SEAT LOCK STRIKER SUB-ASSEMBLY
|
(a) Install the 4 seat lock strikers with the 8 bolts. Torque: 37 N·m (377 kgf·cm, 27 ft·lbf) |
(b) Return the floor carpet to its original position.
3. INSTALL NO. 3 SEAT CUSHION COVER
|
(a) Attach the 16 claws and 4 clips to install the 4 seat cushion covers. |
4. INSTALL FOLD SEAT LEG LOCK SUB-ASSEMBLY
|
(a) Install the fold seat leg lock with the 2 nuts. Torque: 12 N·m (122 kgf·cm, 9 ft·lbf) |
|
(b) Attach the 2 cable clamps. |
(c) Connect the connector.
5. INSTALL NO. 1 WOOFER BOX SPEAKER ASSEMBLY (for RH Side, w/ Woofer)
6. INSTALL REAR ROOF NO. 1 AIR DUCT (for LH Side)
7. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH
8. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
9. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE
10. INSTALL REAR DOOR SCUFF PLATE LH
11. INSTALL REAR STEP COVER
12. INSTALL REAR NO. 2 SEAT ASSEMBLY
(a) Temporarily install the seat with the 4 bolts.
NOTICE:
Be careful not to damage the vehicle body.
(b) Tighten the bolts in the order shown in the illustration.
Torque: 37 N·m (377 kgf·cm, 27 ft·lbf)
(c) Connect the connector.
13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
14. INSTALL REAR NO. 2 SEAT HINGE COVER LH
(a) Attach the 3 claws and 2 clips to install the cover.
15. INSTALL REAR SEAT CUSHION HINGE COVER LH
|
(a) Attach the 3 claws to install the cover. |
(b) Return the seat to the upright position.
16. INSTALL REAR NO. 2 SEAT HEADREST ASSEMBLY LH
|
|