Home › Audio/Visual/Telematics › Cellular Communication › BUS BUFFER ECU
Last Modified: 11-27-2007 1.6 A
Service Category: Audio/Visual/Telematics Section: Cellular Communication
Model Year: 2008 Model: LX570 Doc ID: RM000002PBR003X
Title: CELLULAR COMMUNICATION: BUS BUFFER ECU: INSTALLATION (2008 LX570)

INSTALLATION

HINT:

A bolt without a torque specification is shown in the standard bolt chart SPECIFICATIONS: STANDARD BOLT: SPECIFIED TORQUE FOR STANDARD BOLTS (2008 LX570) .

1. INSTALL BUS BUFFER ECU

(a) Install the ECU with the nut as shown in the illustration.

Torque: 12 N·m (122 kgf·cm, 9 ft·lbf)

2. INSTALL TELEPHONE ECU ASSEMBLY WITH BRACKET CELLULAR COMMUNICATION: MAYDAY ECU: INSTALLATION (2008 LX570)+

3. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY INTERIOR PANELS / TRIM: INSTRUMENT PANEL SAFETY PAD: INSTALLATION (2008 LX570)+

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable some, systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

5. INSTALL ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+

6. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: DIAGNOSIS SYSTEM (2008 LX570) .