| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Exterior | Section: Window/Glass | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002STX00GX |
| Title: WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Front Door): REMOVAL (2008 LX570) | ||
REMOVAL
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
2. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH
3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
4. REMOVE FRONT UPPER ARMREST BASE PANEL
5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
6. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY
7. REMOVE FRONT DOOR SERVICE HOLE COVER
8. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
9. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY
10. REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY
|
(a) Using a T25 "TORX" driver, remove the 3 screws and motor. NOTICE:
Be careful when removing the screws as the motor may fall and become damaged. |
|
|