|
Last Modified: 11-27-2007 |
1.6 A |
|
Service Category: Vehicle Exterior |
Section: Window/Glass |
|
Model Year: 2008 |
Model: LX570 |
Doc ID: RM000002STY00EX |
|
Title: WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): INSTALLATION (2008 LX570) |
INSTALLATION
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed below are for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart
.
1. INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY
|
(a) Apply MP grease to the sliding and rotating areas of the regulator motor.
|
(b) Using a T25 "TORX" driver, install the motor with the 3 screws.
Torque: 5.4 N·m (55 kgf·cm, 48 in·lbf)
HINT:
A new rear window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY
3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY
4. INSTALL REAR DOOR QUARTER WINDOW GLASS
5. INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY
6. INSTALL REAR DOOR GLASS RUN
7. INSTALL REAR DOOR SERVICE HOLE COVER
8. INSTALL REAR SPEAKER SET
9. INSTALL REAR INNER DOOR GLASS WEATHERSTRIP
10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
11. INSTALL REAR UPPER DOOR ARMREST BASE PANEL
12. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
|